We describe the use of tongs that are part of regular kitchenware as occlusal plane guide. To use them, after the relevant scalp incisions are made along with periosteal and temporalis muscle reflection, LeFort III osteotomy is done. The normal dental occlusal plane is placed and it is adjusted according to the mandibular or the palatal planes ([Fig. 1]). Then the tongs are placed with each of the flanges on either side of the face, the plane of the flange being parallel to the decided axis of the occlusal plane ([Fig. 2]). Reference lines are drawn with a marking pen on the bone and then the distractors are placed, the foot plate being in the zygomatic region and the posterior segment over the thickest part of the temporal bone.
Fig. 1 The dental occlusal plane guide used in the required axis.
Fig. 2 Tongs being used in a plane parallel to the required dental occlusal axis to decide on placement of the distractors.
The main aim of midface distraction[1] in conditions such as Aperts and Crouzon is to achieve increased orbital depth[2] and occlusion[3] simultaneously. The most important factor determining the success of this surgery is the vector of distraction. The vector of distraction is predominantly decided preoperatively using cephalometric analysis along with the occlusal planes of the patient already existing and the plane which is desired. A few tools such as horseshoe-shaped occlusal planes in the past have been used in aiding the same step. In an axis parallel to the decided occlusal axis, the distractors are then placed using the surgeon’s judgement. The usage of this results in some error in judgement while placing the device on both sides. The distractors may have a parallax with respect to each other. So, the surgeons then came up with further occlusal guides[4] that can be lines derived cephalometrically or very costly instruments that are biflanged to help combat the problem. These are generally used conjointly with occlusal plane devices.
Tongs are biflanged tools welded at the middle. Any degree of abduction or adduction on one of the flanges produced simultaneous deformation of the other. This helps to keep the modifications bilaterally same. The other important aspect is that the site at which the flanges are welded together at the center does not allow any torque to act upon, and hence the flanges are at the same plane no matter how much they are expanded (withdrawn from each other) or collapsed (brought near each other). This ensures that the plane and the height at which the axis of the midface distractor is proposed parallel to the occlusal plane are in symmetry with that of the opposite side.
